What is important to know about the PAX wardrobe system?
There are many great benefits of PAX. Our flagship wardrobe can be bought ready-made or personalized based on your needs. It is an affordable, adaptable and changeable storage solution that will last for years.
1. Frames
Standard frame
Middle unit
End unit
50, 75 or 100 cm
35 cm
20 cm
201 or 236 cm
201 or 236 cm
201 or 236 cm
35 or 58 cm
35 cm
58 cm
2. Doors, handles and hinges
For hinged doors, match widths as follows:
- 50 cm frame: one 50 cm door
- 75 cm frame: one 50 cm door and one 25 cm door
- 100 cm frame: two 50 cm doors
Standard 195cm
Standard 229cm
Corner 195cm
Corner 229cm
201cm
236cm
201cm
236cm
You can find more information about knobs and handles here.
KOMPLEMENT push-openers are compatible with 50 cm-wide doors, but not with 25 cm-wide doors or corner wardrobes. For a 50 cm frame, use one opener, placed centrally on the side wall or beneath a centrally placed shelf. For a 100 cm frame with two doors, the guidance recommends a shelf roughly halfway up, with the openers below it.
Finishes vary. For example, MEHAMN panels have a different colour on each side.
3. Interior organisers
4. Lighting
50 cm frame
75 cm frame
100 cm frame
75 cm with corner element
100 cm with corner element
Corner element
46 cm
71 cm
96 cm
46 cm
71 cm
46 cm
5. Installation and ceiling clearance
- For safety, assemble PAX with at least two people or use our assembly service.
- Here you will find many products that can be useful in your craftsmanship: TRIXIG Series
- For hinged doors, attach the hinges to the doors first, then attach the doors to the wardrobe. When mounting the hinges on a 201 cm structure, the hinge on the right-hand door will be one position higher than the one on the left-hand door (as shown in the assembly instructions). The FIXA drill template is used to mark the drill holes of knobs or handles and helps to attach them in the same position on each front.
- Drawers can only be placed where no hinge is mounted. If doors collide or do not close correctly, check the assembly and adjust the hinge screws as described in the assembly instructions.
- Sliding-door rails mount on top of the wardrobe and need more clearance.
- External lighting may also require extra space, depending on its height.
- Minimum ceiling height depends on your wardrobe configuration
Hinged doors, 201 cm frame
Hinged doors, 236 cm frame
Sliding doors, 201 cm frame
Sliding doors, 236 cm frame
No door, 201 cm frame
No door, 236 cm frame
202 cm
237 cm
205 cm
240 cm
202 cm
237 cm
Did you find this useful?
Thank you for your feedback!
What particular parts of our documents do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the document not helpful? Try one of the related documents below.
You can find the information in the 'What's included' section in the product page.
Read moreThe PAX wardrobe system comes with different standard sizes, which you can find in the product information pages.
Read morePAX wardrobes are meant to adapt to your changing storage needs - even after assembly you can optimize nearly everything.
Read moreStart by measuring your space, then follow our steb-by-step guide. You can also book a planning appointment with one of our specialists.
Read moreCreate a walk-in wardrobe by putting the PAX wardrobe frames together to fit your space or use the SKYTTA sliding door system if you don't have an extra room.
Read moreWhen you are mounting doors on your PAX wardrobe it is important to consider the height of the ceiling and the placement of the hinges.
Read more