Can UTRUSTA push door openers be used instead of handles/knobs on PAX hinged doors?
Yes, it is possible. The only thing to consider is the correct positioning of the pressure door openers to ensure a convenient opening of the doors.
For a 100cm and a 75cm cabinet, it is recommended to place a shelf approximately in the middle of the cabinet, to place the pressure door openers below the bottom. This is important because otherwise you will have to place the pressure door openers at the top below the top panel or the very bottom and this is not recommended because when you open the cabinet doors, you will also have to press at the top or bottom to open them.
If you have a 75cm frame, note that one door is 50cm wide and the other is 25cm wide. For a 100cm frames, install in the middle, because both cabinet doors are 50cm.
With a 50cm frame, you only need one pressure door opener. This can be installed approximately in the middle of the side wall of the frame to ensure a convenient opening. It should also be noted that it should be placed on the correct side wall, not on the side wall with the hinges.
Did you find this useful?
Thank you for your feedback!
What particular parts of our documents do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the document not helpful? Try one of the related documents below.
PAX doors are not pre-drilled, so you can choose which knobs and handles to use and where to place it on the door.
Read moreFor the PAX unit with the height of 201cm, the doors with hinges are 195cm high. For the PAX unit with the height of 236cm, the hinge doors measure 229cm in Height. Not all doors are available in the height of 195cm.
Read moreThis might happen when the doors have not been fitted correctly. If you have reviewed the assembly instructions carefully and still need support, you can contact us.
Read moreIKEA does not have 60x60 drawer fronts for kitchens. But with the article UTRUSTA drawer fitting for door (item number 202.699.31) the 60x60 door can be converted to a drawer front. You can see how it works in the assembly instructions enclosed with the article.
Read moreThe suitable hinges for PLATSA are called HJÄLPA , they are packed separately.
Read moreAll sliding doors have an integrated soft-closing devices, this no longer needs to be booked separately.
Read more