How do I ensure that my TRÅDFRI light bulbs are synchronized?
It is possible that your TRÅDFRI light bulbs are no longer synchronized, for example by switching them on and off manually. You solve this by pressing the button to make the light brighter, until the light sources have the same position. After that, your light bulbs are synchronized again.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
To make installation as easy as possible, you'll find assembly guides for our TRÅDFRI products at the front of IKEA.nl/en. What's more, alongside the installation guides, we've made videos to help you with the installation step by step!
Read moreOpen the motion sensor on the back and insert the supplied batteries. Set the pointer to the moon to have the light react to the motion sensor only when it is dark, or set it to the sun so that the sensor always works.
Read moreOpen the IKEA Home Smart app and go to 'Scenes'. You can easily create a shortcut from there. Before that, you need to pair the shortcut button first.
Read moreYou can illuminate your countertop with IRSTA, MITTLED, SKYDRAG and YTBERG countertop lighting.
Read moreRemove the cover from the gateway and use a pin (or something similar) to press and hold the reset button for 5 seconds. While pressed, the three lights flash. If the middle light then flashes 2 times quickly, your gateway has been reset to the factory default settings.
Read moreBefore you can use your light bulb, it must be connected to the system. Make sure the light bulb is in the lamp and the main switch is on. Then you can hold the remote or dimmer close to the light bulb to add it to your system. Press and hold the pairing button for at least 10 seconds.
Read more