There is no hole in the assembly manual, but I have to tighten the screws. Do I have to drill holes myself?
There is a part designed to fasten the screw even no perforation hole.
In this case, please refer to the assembly instructions and tighten the screws directly to the product.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
For steel products such as HELMER drawer units, the screw holes may be too small to assemble. This is a part designed to tighten the screws tightly. Please tighten the screws very strongly or use an electric screwdriver.
Read moreTo access our product assembly instructions, you can search for the product using the name or article number in the search field on our website. You can download the information document (in PDF) from the product page, in the "Assembly and documents" section.
Read morePlease take care of your IKEA furniture products so that you can use for a long time. Please refer to the following notes.
Read moreThe IKEA product assembly instructions are shown in the figure so that people around the world can see and understand it. I'll let you know a few important things.
Read moreThe back panel of IKEA furniture products may be folded in half in a flat pack.
Read moreIf our assembly service is not satisfying or you find a problem while using the assembled product, please contact our with the order sheet.
Read more