Why is there a gap between my BESTA unit shelf and door or drawer front?
The BESTA shelves will come with a standard bracket however when you purchase drawer runners or hinges, these will come with an alternate bracket for you to use which eliminates the gap.
The BESTA unit will come with standard brackets. When you purchase drawer runners or hinges, you will find alternative brackets with these items. Installing the alternative brackets will remove the gap between your shelf and door or drawer front.
For your reference, the alternative parts are parts 115444 and 115443 listed in the assembly guide of your drawer runners or hinges. Using these components will ensure the shelf sits level with the top of your door or drawer front and not sit above.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
If you have installed BESTA push open runners (104.883.16), your unit will have a slight gap between the drawer front and frame to allow space for the door to be pushed.
Read moreThe BESTÅ fronts do not have pre-drilled holes for handles, allowing you to choose between installing handles or going with push openers.
Read moreMost of our flatpack furniture comes with the holes predrilled. It is common however to see modular or customisable ranges to not have predrilled holes, to allow you to determine where things should go.
Read moreIf your cabinets are from the METOD range, you have the flexibility to choose any finish and swap out the doors or drawer fronts. However, if your cabinets are from the old FAKTUM range, you won’t be able to switch to the door models currently available.
Read moreTo remove a MAXIMERA drawer front, you'll need a Phillips head screwdriver and access to the side panels of the drawer. Refer to the steps at the end of your MAXIMERA drawer assembly document for illustrated guidance.
Read moreOur MAXIMERA drawer fronts offer 3 types of adjustment to help you perfectly align your new kitchen cabinets. Also, there are specific instructions for installing drawers depending on where you install them in the cabinet.
Read more