I’ve installed my lights but when I try to pair them, a different light responds.
If you have a light source with more than one light bulb that sits close together, you need to pair them one by one. Install your first light bulb, pair it and then remove it. Then install the second light bulb, pair it and remove it, etc. Do this with all of the light bulbs, installing all when you’re ready.
You can also watch a film for instructions:
How to add a light bulb when the lamp has more than one light bulb
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
There are simple steps to complete this.
Read moreThe first steering device will unpair or become disconnected from the light source.
Read moreYou always need to have a steering device to be able to control your light bulb.
Read moreTo get two steering devices to control the same group of lights, make sure that you have one steering device that is controlling the desired lights and one steering device that is reset to factory settings.
Read moreYou can’t change colour with a wireless dimmer.
Read moreYou can steer your lights without the remote control if you disconnect the steering device from the gateway after you have used it to pair your light sources.
Read more