25 year guarantee
25 year guarantee. Read about the terms in the guarantee brochure.
Article Number791.573.90
Product details
LÅNGUDDEN inset sink is slightly deeper at the back edge, so you can place things like washing-up detergent and a dish-washing brush on the steel edge instead of on your worktop.
Sink in stainless steel, a hygienic, strong and durable material that's easy to keep clean.
Under the sink is a sound-absorbing material which reduces resonances in the metal when using the sink, thus lowering the sound level.
Designer
IKEA of Sweden
Measurements
- Bowl, depth: 18 cm
- Bowl, width: 40 cm
- Bowl, front to back: 33 cm
- Cut-out measurement width: 44 cm
- Cut-out measurement length: 44 cm
- Front to back: 46 cm
- Length: 46.0 cm
- Depth: 45.5 cm
- Volume: 18.0 l
Reviews
Perfect one bowl sinkPaigeI have this sink in my kitchen and my laundry. Love the extra large lip on the far side.
Exactly what we neededJacquiGreat product plumber found it easy to connect up and fit
Hard to fitMarkFitting clips to short
Great little sinkPaulA great little sink. A little bit thin, but still holds heat to wash dishes for a good amount of time.
The brackets to fit it aren’t the best quality though and that’s why it lost a star as it made it difficult to fit perfectly.
Already rustingKarenWe purchased this sink to use in our laundry and it is already showing signs of rusting. We have only been using it for a few months so it was pretty disappointing. No washing detergent or other chemicals have been used in the sink - only hand soap.
Small SinkJonSmall Sink
Langudden SinkPaulLooks great and good size for my new laundry!
Laundry sinkLeoGreat size laundry sink
Cheap but you get what you pay forRyanBottom not level enough for water to drain correctly, always have to wipe down to avoid water stains.
And locking clip used to seal to counter top, one of them was stripped and so could not be attached correctly.
Cheap and good use of spaceChrisFirst off we liked the price and square finish. It's quite a large sink so difficult to do a plunge cut with circular saw (ran out of space at the back), a jigsaw really is the way to go with this sink. A rubber seal is underneath so you shouldn't need to caulk it in. What this does need is a paper template to help me draw out where to cut. Instead the instructions say to place it face down and trace, subtract 10 mm which I personally think is harder than it needs to be. The waste hole is really far forward so be ready for that, I'd have liked it closer to the tap because my S trap couldn't reach the waste at full extend. Fits 40mm and 50mm waste pipes with the included adapter. I would have liked there to be a grade toward the waste hole, I am finding water ponds at the bottom and doesnt fully drain away.
Customer reviews
4.2Average rating
312Reviews