Can the ATLANT sink stopper be replaced with a sink stopper from today’s product range?
We do not recommend replacing the ATLANT sink stopper with any sink stopper from our current product range, as they do not share the same dimensions. However we can recommend a sink stopper from Clas Ohlson, which has similar measurements to the ATLANT sink stopper.
The ATLANT sink stopper has different dimensions compared to the sink stoppers available today, both in terms of the gasket size and the overall design. Because of these differences, the modern stoppers in our range do not seal properly and are therefore not suitable replacements. A sink stopper from Clas Ohlson can be a good alternative, as its measurements come closer to those of the ATLANT stopper. We recommend checking the measurements before purchasing to ensure the best possible fit.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
LILLVIKEN water trap can be used with most of the IKEA sinks. Enlarge this answer to read more about how LILLVIKEN is installed with our different sinks and which sinks are not compatible with LILLVIKEN.
Read moreTo be able to underglue your sink, an MS polymer glue is needed. The glue is a mixture of glue and silicone that both glues and seals.
Read moreFor ENHET kitchens, with the exception to AMMERÅN and HAVSEN, you can use all our sinks for 60 cm wide sink cabinets. To complete the combination, remember to add the LILLVIKEN water trap.
Read moreWhen installing a blind front, use the angle bracket and screws that come with the METOD base cabinet frame intended for sinks. How to install the blind front is shown in the installation instructions for the base cabinet frame.
Read moreWhen you order a custom-made worktop in laminate or thick veneer from IKEA, we can make various cut-outs or adjustments to your worktop to make it perfect in your kitchen. These cut‑outs or adjustments are referred to as HACKBOL in your order.
Read moreTo make your installation as smooth as possible, our METOD base cabinets for built-in oven and sink (60 and 80 cm) come with a pre‑cut opening in the bottom panel. The white 80 cm cabinets also include an additional cut‑out in the back panel, making it both easier and safer to route pipes and cables.
Read more