Why is there a gap between my BESTA unit shelf and door or drawer front?
The BESTA shelves will come with a standard shelf supports. However, if you purchase drawer runners or hinges, you will get shelf supporters alternatively for you to use which eliminates the gap.
For your reference, the alternative spare parts are 115444 and 115443 listed in the assembly guide of your drawer runners or hinges. Using these components will ensure the shelf sits level with the top of your door or drawer front and not sit above.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
If you've installed BESTA push open runners (104.883.16), the slight gap between the drawer front and frame is necessary for the push-open mechanism to work properly.
Read moreThe holes in the BESTA are not predrilled so that you can choose the exact handle and positioning of the handle you are after.
Read moreLooks like your order and the product is just fine – it’s wearing a little protection!
Read moreRefrigerators and freezers can sometimes emit different sounds, usually it is normal operating noises that ensure that the product works as it should. Sometimes, however, the sound may indicate that the freezer needs a manual defrost.
Read moreThis is possible for MAXIMERA high drawers as we carry high, medium and low drawer sizes.
Read moreIt's simple! There is a panel on either side of the drawer where you can unlock the drawer frame from the drawer front.
Read more