Skip to main content

How do I factory reset my Home smart kit?

You can reset your IKEA Home smart products back to the original settings (Factory reset) by following the simple steps here.

Light sources:
Toggle the main switch 6 times.

Remote control, wireless dimmer or motion sensor:
Press the pairing button 4 times within 5 seconds.

Gateway:
Open and remove the gateway lid. Push a pin into the pinhole on top of the gateway for at least 5 seconds until the LED light stops flashing.

Control outlet:
Push a pin into the pinhole on top of the control outlet for at least 5 seconds until the LED light stops flashing.

Signal Repeater:
Push a pin into the pinhole on the bottom of the signal repeater for at least 5 seconds.

Blind:
Press both up and down buttons on the blind for 5 seconds.

 

You can watch our videos below for a visual guide on how to reset your smart products:

How to reset TRÅDFRI Light Bulb

How to reset TRÅDFRI Remote Control

How to reset TRÅDFRI Wireless Dimmer

How to reset TRÅDFRI Motion Sensor

How to reset TRÅDFRI Gateway

 

 

 

What particular parts of our answer do you find unsatisfactory or unhelpful?

The text is confusing to understand

The text is not relevant to my question

The text is relevant but not helpful

The text is too long or too short

Thank you for your feedback!