Review VictorExcellent, if possible have some adjustment height 5
Definitely neededLindaNeeded this part for stability.5
Assembly instructions MichaelI still can’t figure out how to assemble the legs and the part that you display above. A waste of money and I wish that you would refund my money, you can have it back! 1
Well designed, functional leg for long tv standRyanOnly wish our metal corner legs had a similar polished (non-painted) metal leg to match in the middle. 5
Looks Good But...DavidI have a wide BESTA TV stand for which I just purchased 4 NANARP legs and didn't think it would need the support because there's no weight on the stand and the TV is wall mounted. It started to sag in the middle as soon as the legs were installed so I purchased a support. Didn't realize the holes on the bottom are on either side of center so my 1 support is off-center and I'll probably need to get another one - so that's 3 separate shipments to get it right. Also the side with 2 wood screw holes should match the other side to use the pre-drilled screw anchors on the stand - seems like that would have been the logical design choice. Would also be nice if there was a tool included to adjust the height of the support foot when it's on the ground instead of having to use a wrench or lift the furniture.3
GoodBelkisGood support piece5
Holds it upLawrenceMake sure you have at least one for the Besta unit. Supports the center of the cabinet when using the optional legs. 5
Useless NicoleI have slid my unit a few times approximately three feet back and forth to clean and now the metal Besta leg is bent. It has become useless. I should have purchased another set of legs to use one for the middle support. 1
Not supportive enoughLaurenEasy to install on the Besta cabinet just don't expect it to last, especially if you have a TV on the cabinet or anything remotely substantial stored inside it. The whole cabinet started bowing after only a little while and it just keeps getting more noticeable especially since it throws off the door alignment. After only a couple years so I will need to swap to the low legs or find another solution.2
GoodAlbertoGood.5
Jury is still outErnestI installed them and made adjustments. Although, my home is relatively new, less than five years old, the floors are not precisely level, I decided to uninstall them because it only emphasized the console needs to be bolted to the wall. Right now, I have the console still on the floor using the “flat” or default legs. When I get the time to revisit properly mounting my console up to my liking, finding a wall stud, I will tackle using this or not. I am in no rush.3
Easy to installMikeWorks great5
would have preferred they matchedMarywould have preferred they matched the legs in appearance4
LOVE! LOVE! LOVE!!!WilliamLOVE! LOVE! LOVE!!!5
Doesn't fitKennethThis piece doesn't fit the two-unit Bestå TV shelf that it was sold with. The better option is to just buy two extra feet to go in the middle of the shelf.2
What is this for--PatriciaThe instructions for assembling this cabinet did NOT fully show, explain, or give steps/options on how to use this and other pieces ...1
Necessary when using legsEmilioThis hidden leg is necessary when using a BESTA in horizontal position with legs. This relieves pressure from the cabinet preventing it from arching.
It comes with one wood screw. The other side attaches to the pre-built hole on the BESTA cabinet.
Make sure to adjust the foot so it's leveled with the legs.5
ExcellentJuanExcellent5
Works!StephenWorks!5
Great productHarithaGreat product1
