Skip to main content

How do I connect ÅSKVÄDER with a controller?

You connect ÅSKVÄDER to a controller by holding the controller close to the switch and pressing the pairing button for about ten seconds until the controller shows a steady red light and the ÅSKVÄDER switch blinks white to confirm the pairing.

To switch ÅSKVÄDER on/off switch with a controller:
1. Make sure your ÅSKVÄDER switch is securely fastened and that the power is plugged in.
2. Hold the controller close to the ÅSKVÄDER on/off switch you want to add (the distance must be no more than 5 cm).
3. Press and hold the pairing button for at least 10 seconds. You can find the pairing button under the rear cover of the controller.
4. A red light is solid on the controller. On your ÅSKVÄDER on/off switch, a white light will begin to dim and flash once to indicate that it has been paired.
Up to 10 ÅSKVÄDER on/off switches can be paired with 1 controller. Make sure you pair them one at a time. If the ÅSKVÄDER on/off switches are close to each other, disconnect those that have already been paired from the mains.

Turning the device on/off:
Press the on/off button to control outlets/devices connected to the ÅSKVÄDER on/off switch. 
Factory reset your device:
Push a pin into the hole at the top of the ÅSKVÄDER on/off switch for at least 5 seconds to reset your device to factory settings. 

What particular parts of our articles do you find unsatisfactory or unhelpful?

The text is confusing to understand

The text is not relevant to my question

The text is relevant but not helpful

The text is too long or too short

Thank you for your feedback!

Was the article not helpful? Try one of the related articles below.