Start by checking if it's a low, medium eller high drawer. The hole placement can vary depending on the height and where you want to place the drawer in your base cabinet.
Use the assembly instructions to check that the rails are mounted in the correct holes in the base cabinet according to where you want the drawer to be placed and whether it has a visible front or is a hidden drawer. The wrong hole gives the wrong height and can cause the overlap.
Why do all my drawer fronts have a difference of about 1 cm?
If your drawer fronts overlap, it may be because the rails or fittings that attach the drawer front are not mounted correctly. Check that the rails are in the correct holes and that the screws for the bottom drawer front fittings are positioned as directed.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Figuring out which inner drawer you should have can be a bit tricky as the size of the drawer fronts for METOD kitchen is named in the drawer front's name by centimeters (WidthxHeight), while the size of the drawers (MAXIMERA and KNIVSHULT) is named by three heights - low, medium and high. To make it simple, you can think that a low drawer is 10 cm high, a medium drawer is 20 cm high, and a high drawer is 30 cm high.
Read moreIf the drawer hits the water trap or adjacent fronts, it’s usually due to incorrect installation. Please check that the drawer runner is positioned correctly and that the bracket between the drawer and the front is mounted according to the instructions - this depends on the drawer’s placement in the cabinet.
Read moreIf your doors or drawer fronts are not aligned with each other, you can adjust them by tightening the hinges for the doors or the drawer rails for the drawer fronts. The adjustment ensures that the doors and drawer fronts are at the correct height and position, which can be done both up, down, to the right, and to the left, depending on which part needs fine-tuning.
Read moreSmall bubbles on BESTÅ doors and drawer fronts appears due to a thin protective film that is applied to protect the product during delivery. This film should be removed during assembly.
Read moreAlthough the BESTÅ family was updated in 2015, the new BESTÅ drawers are still compatible with older cabinets purchased before 2015. Keep in mind that the drawers need to be completed with a drawer front.
Read moreA cover panel is a decorative panel that is mounted on the side of a cabinet to give the kitchen a uniform and stylish look.
Read more