To add a light source to your Gateway:
You’ll need a steering device—such as a remote control, wireless dimmer, or motion sensor. Follow the steps in the app:
I’m unable to add the light source to the TRÅDFRI gateway
To add a light to your gateway, you must first set up a control device, which will then allow you to connect and manage your light sources.
- First, connect your steering device to the gateway.
- Then, pair your light sources with the steering device.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Easily Connect Your App or Phone to the TRADFRI Gateway – Just Follow These Steps:
Read moreAny TRÅDFRI light source can be controlled using TRÅDFRI gateway
Read moreReconnect it using the steering device to restore the link.
Read moreYou can reset your IKEA smart lighting products back to the original settings
Read moreAdding a second steering device will cause the first one to unpair from the light source.
Read moreYou’ll need a steering device to operate your light bulb at all times.
Read more