When do I use the VÅGLIG connecting rail?
The VÅGLIG connecting rail mainly allows you to have two or more fronts on your dishwasher so that it has the same look as the rest of your kitchen. The clutch belay is also used in individual cases if you have a full door and the handle BILLSBO.
How you install the drawer fronts depends on the dishwasher and the distribution of fronts you have chosen for your kitchen.
VOXTORP fronts - The hinge holes on VOXTORP are positioned lower than usual, which means that the included fittings do not fit.
BILLSBO handles on either ÖSTVEDA, KALLBODA or TORSBODA dishwasher.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Profiled handles, such as BILLSBRO, are mounted on the back of a front or door, which can create challenges when connecting the front to the dishwasher.
Read moreHow you attach a drawer front to your dishwasher depends on both the dishwasher model and the front you have chosen. In the assembly instructions for the VÅGLIG connecting rail, which you need to mount the front onto the dishwasher, you'll find the specific details for your specific dishwasher model.
Read moreThe VÅGLIG connecting rail is not compatible with FAKTUM.
Read moreThe new ceiling fitting for the VIDGA curtain rail system is smaller than the previous one, which means that the rail ends up closer to the ceiling. It is therefore not possible to combine the older ceiling fittings with the new ones, all ceiling fittings need to be replaced with the new ones in order for the rail to end up at the same height.
Read moreWe sell two UTRUSTA connecting rail for fronts in two different variants, one white and one black-grey. This is to match the look of the rest of the kitchen. The white one is used for MAXIMERA drawers while the black-grey one is used for KNIVSHULT.
Read moreIt is only possible to make a corner solution with a VIDGA 1-track rail.
Read more