Can I have a corner solution on the VIDGA 3-track rail?
It is only possible to make a corner solution with a VIDGA 1-track rail.
If you want to make a corner solution, you need to use a single-track rail. It is not possible to create a corner solution with multi-track rails. If you put the VIDGA corner against a multi-track rail, it will end up at the wrong angle and the hooks would not be able to slide further. Likewise, two tracks from the curtain rail were to be left open. This applies to both ceiling and wall fittings.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
The new ceiling fitting for the VIDGA curtain rail system is smaller than the previous one, which means that the rail ends up closer to the ceiling. It is therefore not possible to combine the older ceiling fittings with the new ones, all ceiling fittings need to be replaced with the new ones in order for the rail to end up at the same height.
Read moreKVARTAL, which was our previous curtain hanging system, is not compatible with VIDGA because VIDGA has a different design.
Read moreWhen installing the VIDGA curtain rail, a maximum distance of 130 cm applies between the included ceiling fittings. If you use VIDGA wall brackets instead, which are sold separately, the maximum distance between the wall brackets can instead be up to 135 cm.
Read moreThis is usually due to a faulty assembly, where the fitting with the number 146957 has not been installed correctly.
Read moreIn a PAX corner solution, in cases where you can have a door, there should only be handles on one of the doors so that they can be opened freely. The second door opens using the grab strip that comes with the PAX add-on unit.
Read moreIf your 40 cm wide BILLY corner shelf is placed between other shelf frames, we do not recommend installing a hinged door, as it may hit the unit next to it. However, if your BILLY corner shelf is freestanding, adding a hinged door works perfectly.
Read more