RÄSKOG/The screws are too short to reach.
In the process of screwing the shelf, check whether the square part at the bottom of the screw head matches the square screw hole on the plate.
Check that the square part at the bottom of the screw head matches the square screw hole on the plate. If you fit the square part, it will go one step deeper.
Watch a video on how to build RÅSKOG *Japanese only
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Slowly push it from above
Read moreThe screw holes for cross braces have smaller screw holes for safe use of the product. Secure the cross brace from below and slowly push the screw with a screwdriver.
Read moreWhen attaching the legs to the columns in step 3, if the legs are turned in the opposite direction, the screws will not fit. In addition, steel products have almost the same thickness of screws and screw holes, so there is a feeling that it is difficult for screws to enter. If the size of the screwdriver is not correct, there is a possibility that the screw thread will be licked, so please use a positive screwdriver that matches the size and install it so that you push the screw around with force from above.
Read moreIf you notice that you made a mistake on the front and back of the riser plate at the foot near the end of the assembly, instead of pulling out all the nails driven into the back board and reassembling, you can unlock the cam lock and assemble.
Read moreThere are two types of screws of similar shape, large and small. Please check again.
Read moreIKEA recommends you to use wall fixing screws that are suitable for your walls. As wall materials vary, screws for wall fixation are not included.*
Read more