I can not fit the screws for the MULIG clothes rack.
When attaching the legs to the columns in step 3, if the legs are turned in the opposite direction, the screws will not fit. In addition, steel products have almost the same thickness of screws and screw holes, so there is a feeling that it is difficult for screws to enter. If the size of the screwdriver is not correct, there is a possibility that the screw thread will be licked, so please use a positive screwdriver that matches the size and install it so that you push the screw around with force from above.
Please take a look carefully. The screw holes on the legs have small and large holes. The holes on the legs should have small screw holes on the inside and large screw holes on the outside. Screws are tightened from the large screw hole (outside).
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Allow play without overtightening the screws and assemble them while adjusting. If the sides of the shelf are wide, use pliers or the like to bend them inward to facilitate screwing. If you assemble while tightening all the screws, the screw holes will not fit in the later process.
Read moreIn the process of screwing the shelf, check whether the square part at the bottom of the screw head matches the square screw hole on the plate.
Read moreThe fittings to attach IVAR shelf board are packaged between the parts at both ends of the shelf board. Please check for them there.
Read moreSlowly push it from above
Read moreThe screw holes for cross braces have smaller screw holes for safe use of the product. Secure the cross brace from below and slowly push the screw with a screwdriver.
Read moreWe are very sorry for the inconvenience caused. Please bring your product with your proof of purchase (receipt, tax invoice, IKEA Family member history) to the Returns Counter on the first floor of the IKEA Store where you purchased it. We will hand over the missing parts.
Read more