The desk board of MICKE is so hard that screws cannot be inserted.
Slowly push it from above
Since the screw holes for the screw (fitting number: 121817) are only halfway threaded, the speed of turning them will slow down, but you can tighten them firmly to the end by slowly pushing and turning them from above.
The reason why it is not threaded to the end is to firmly support the steel legs.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
-
The casters of the swivel chair do not work, is this defective?
While sitting in the chair, try moving it forward, backward, left and right.
Read more
-
What is the weight limit of IKEA desks?
IKEA desks have a weight limit of 40–50 kg.
Read more
-
The drawers side panels are the same for both left and right.
This product contains identical side panels. You can use them on the left or on the right side by turning them upside down.
Read more
-
What is the replacement to BEKANT?
The successor to BEKANT is MITTZON.
Read more
-
The shelf support parts of the MICKE desk with storage are stiff. I can’t get them in.
The shelf supports will be stiff when you fit them, so please use a hammer as necessary. If you have to remove them, try using pliers.
Read more