Skip to main content
EN JPEnglish

Do I need to attach large storage furniture like a PAX wardrobe to a wall?

Yes. Large storage units like PAX wardrobes need to be attached to a wall to keep them from falling over.

Large storage units like PAX wardrobes need to be attached to a wall to keep them from falling over. Wall anchoring screws are not included with products because you need different wall anchoring screws depending on the material your wall is made of. Please provide your own wall screws. See below for more information on choosing wall anchoring screws that are right for the material your wall is made of.

Wood Walls
Use regular wood screws for wooden walls with strong studs that can hold screws. You do not need to pre-drill holes.

Concrete Walls
Drill screw holes first if you have concrete walls. You will need plastic anchor plugs to keep your screws in place. Mark where you want the screw to go and drill a hole. Then, insert an anchor plug and tap it in with a hammer. Then, screw in the screw. Make sure to use a screw that's longer than the plug. If you use a screw that's shorter than the plug, you will not be able to remove the plug later.

More about wall anchoring guide

 

What particular parts of our articles do you find unsatisfactory or unhelpful?

The text is confusing to understand

The text is not relevant to my question

The text is relevant but not helpful

The text is too long or too short

Thank you for your feedback!

Was the article not helpful? Try one of the related articles below.

  • There’s a gap between the front panels of my BEST drawers and the shelf.

    If you are combining drawers with shelves, the fittings for fixing shelves in place are different. Please use fittings attached without INREDA drawer fronts.

    Read more

  • I can't find the parts to attach my PAX shelves.

    It is contained in a small bag at the side of the PAX shelves.

    Read more

  • What parts do I need to buy when purchasing a bed from IKEA?

    Most of our beds are available in a combination of bed frame, bed base and mattress.

    Read more

  • The side panels included in the PAX frame are the same for both left and right.

    This product contains identical side panels.

    Read more

  • I can’t find the parts I need to fit my IVAR shelves.

    The fittings to attach IVAR shelf board are packaged between the parts at both ends of the shelf board. Please check for them there.

    Read more

  • I received only three wall attachment fittings for the back of my mirror.

    Mirrors with fittings at three points on the back can be placed both vertically or horizontally. Please use the upper two fittings.

    Read more