I have more than one bulb connected to my motion sensor and they’ve become un-synced. How can I sync them again?
Re-syncing your bulbs is easy! Here's how to do it
To get your light bulbs back in sync, you need to factory reset your motion sensor along with all connected light sources and then turn them on again and re-sync them. Your set-up will be ready to use again as before!
Did you find this useful?
Thank you for your feedback!
What particular parts of our answer do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
You need to re-pair the bulb with the steering device after connecting the Gateway since the connection may have been lost when you connected the steering device to the gateway.
Read moreLight sources can become out of sync when you interact with the main power switches (wall or lamp switches) with part of your connected light bulbs.
Read moreA simple guide to add or remove your TRÅDFRI Light Sources.
Read moreYou can reset your IKEA Home smart products back to the original settings (Factory reset) by following the simple steps here.
Read moreYou will need a steering device in order to add a light source to the TRÅDFRI gateway.
Read moreA simple guide to installing your TRÅDFRI Smart Kits.
Read more