How do I factory reset my Home smart kit?
You can reset your IKEA Home smart products back to the original settings (Factory reset) by following the simple steps here.
Light sources:
Toggle the main switch 6 times.
Remote control, wireless dimmer or motion sensor:
Press the pairing button 4 times within 5 seconds.
Gateway:
Open and remove the gateway lid. Push a pin into the pinhole on top of the gateway for at least 5 seconds until the LED light stops flashing.
Control outlet:
Push a pin into the pinhole on top of the control outlet for at least 5 seconds until the LED light stops flashing.
Signal Repeater:
Push a pin into the pinhole on the bottom of the signal repeater for at least 5 seconds.
Blind:
Press both up and down buttons on the blind for 5 seconds.
You can watch our videos below for a visual guide on how to reset your smart products:
How to reset TRÅDFRI Light Bulb
How to reset TRÅDFRI Remote Control
How to reset TRÅDFRI Wireless Dimmer
How to reset TRÅDFRI Motion Sensor
Did you find this useful?
Thank you for your feedback!
What particular parts of our answer do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Follow the instructions on the Home smart App or see below for additional support.
Read moreOn the blind, press both buttons together for more than 5 seconds.
Read moreA simple guide to installing your TRÅDFRI Smart Kits.
Read moreA simple guide to add or remove your TRÅDFRI Light Sources.
Read moreA simple guide to add or remove your TRÅDFRI Steering Devices.
Read more