I don't know where to attach the FIXA screwdriver/drill bit holder.
The bit holder attaches to the tip of the screwdriver.
How to install the bit holder
-
Turn the sleeve in the RELEASE direction and retract the chuck at the tip to the back.
(!) POINT:In the state after purchase, the chuck is in the back. If you keep turning the sleeve in the GRIP direction while fixing it by hand so that the ring does not rotate together, the chuck will come out. -
Insert the bit holder with the tip of the chuck slightly deeper, and then turn the sleeve in the GRIP direction to secure it.
Learn how to use a screwdriver/drill(Japanese only)
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
-
What is the approximate initial charge time for FIXA/Screwdriver/Drill 7.2V?
Charging is completed in 3~8 hours. When charging, the red LED indicator will light up and turn off when charging is complete.
Read more
-
How can I find details about an IKEA product?
More detailed information about our products, such as dimensions, weight, package measurements and other useful information, can be found directly on the product page.
Read more
-
What sort of screws should I use to anchor furniture to walls?
IKEA recommends you to use wall fixing screws that are suitable for your walls. As wall materials vary, screws for wall fixation are not included.*
Read more
-
I don't know how to adjust the torque of the FIXA screwdriver/drill.
The torque can be set between 1 and 15, and the higher the number, the stronger the tightening force. In addition, since it has a stopper function, if the screw is jammed, it will spin idle and the screw head will not collapse.
Read more
-
Can I remove the nails on the backboard that I installed by mistake?
If you attach the backboard by mistake, you can remove it depending on the situation. However, basically, products that are assembled using nails cannot be disassembled and reassembled for use.
Read more
-
My product didn't come with screws for attaching it to a wall.
For safety reasons, please attach your IKEA product to a wall if instructed to do so by the assembly instructions. Wall anchoring screws are not included with products because you need different wall anchoring screws depending on the material and structure of the surface your product will be attached to.*
Read more