Skip to main content
EN JPEnglish

Can I attach IKEA curtains to Japanese rails?

Yes, you can. Curtains labeled "heading tape" on each product page can be attached to the rails with your own adjuster hook. 

You can attach those curtains labeled "heading tape" on each product page to rails using your own adjuster hook. 

For curtains without heading tape, use the RIKTIG curtain hooks  to pinch the top of the curtain and hang it on the curtain rail ring.

 

What particular parts of our articles do you find unsatisfactory or unhelpful?

The text is confusing to understand

The text is not relevant to my question

The text is relevant but not helpful

The text is too long or too short

Thank you for your feedback!

Was the article not helpful? Try one of the related articles below.

  • I can not fit the screws for the MULIG clothes rack.

    When attaching the legs to the columns in step 3, if the legs are turned in the opposite direction, the screws will not fit. In addition, steel products have almost the same thickness of screws and screw holes, so there is a feeling that it is difficult for screws to enter. If the size of the screwdriver is not correct, there is a possibility that the screw thread will be licked, so please use a positive screwdriver that matches the size and install it so that you push the screw around with force from above.

    Read more

  • How I should look after my cutting boards?

    Before using the chopping board for the first time, it should be treated with oil approved for contact with food, for instance vegetable oil. Oil once, wipe off any surplus oil and then repeat the treatment 24 hours later.

    Read more

  • When assembling BILLY, the bobbin-like parts (cam lock) did not come off. Is there a way to remove it?

    If you notice that you made a mistake on the front and back of the riser plate at the foot near the end of the assembly, instead of pulling out all the nails driven into the back board and reassembling, you can unlock the cam lock and assemble.

    Read more

  • Can I assemble this with a typical IKEA cross-head screwdriver?

    Cross screw heads used in IKEA products are often Pozidriv screws, which are commonly used in Europe. When assembling IKEA furniture, you can use a screwdriver for the cross (Phillips) screw heads commonly used in Japan. However, screwdrivers for Pozidriv screws allow you to use more force and make it easier to tighten screws.

    Read more

  • What is the weight limit for IKEA products?

    Check the IKEA.com product pages, as several of our products contain information about load capacity.

    Read more

  • The shelf support parts of the MICKE desk with storage are stiff. I can’t get them in.

    The shelf supports will be stiff when you fit them, so please use a hammer as necessary. If you have to remove them, try using pliers.

    Read more