My doors/cabinet doors are crooked, how do I get them to be straight?
You can adjust the position of your doors and doors using the screws attached to the hinges. In the installation instructions for your hinges, which you can find in the table below, you can see which screws you need to adjust to make your cabinet doors straight.
Furniture series | Hinges | Article number |
METOD | 202.619.92 | |
METOD | 202.046.47 | |
METOD | 104.272.62 | |
METOD | 504.624.80 | |
METOD | 704.624.79 | |
METOD | 704.624.84 | |
METOD | 904.624.83 | |
PAX | 302.145.04 | |
PAX | 002.145.05 | |
PAX | 503.684.92 | |
PAX | 103.684.89 | |
BESTÅ | 802.612.58 | |
PLATSA | 603.312.00 | |
PLATSA | 903.828.82 |
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
If your doors or drawer fronts are not aligned with each other, you can adjust them by tightening the hinges for the doors or the drawer rails for the drawer fronts. The adjustment ensures that the doors and drawer fronts are at the correct height and position, which can be done both up, down, to the right, and to the left, depending on which part needs fine-tuning.
Read moreSince all kitchens are unique, you cut your own piece from a cover panel to match the door or space you want to cover. We always recommend a space of at least 50 mm between the wall and the cabinet, which you can cover with a fitting piece, so that you can open drawers and doors without any problems.
Read morePAX doors with hinges are not pre-drilled, so you can choose which knobs and handles to use and where to place it on the door.
Read moreTo remove the drawer front from a RATIONELL drawer purchased after February 2009, tilt up the plastic part located on the outside of the drawer and then pull it straight out from the drawer. Repeat this on both sides of the drawer to remove the drawer front.
Read moreOur doors and drawer fronts are delivered without pre-drilled holes, so you can freely choose and place the handles and knobs you want.
Read moreYes, you can! At the moment, we have three different doors and drawer fronts that you can choose from to update your kitchen. You can either get help from our staff in one of our stores or customer service to place an order. Please note that FAKTUM products today have different names than when they were previously sold.
Read more