Skip to main content
EN JPEnglish

What is the weight limit of IKEA desks?

IKEA desks have a weight limit of 40–50 kg.

IKEA desks can easily bear the combined weight of computers and printers, but please make sure to distribute this weight across the surface evenly. Avoid concentrating the weight all on one spot.

What particular parts of our articles do you find unsatisfactory or unhelpful?

The text is confusing to understand

The text is not relevant to my question

The text is relevant but not helpful

The text is too long or too short

Thank you for your feedback!

Was the article not helpful? Try one of the related articles below.

  • The time display does not light up when batteries are inserted in NOLLÅTTA alarm clock. What should I do?

    Please connect the USB cable.

    Read more

  • Can I attach IKEA curtains to Japanese rails?

    Yes, you can. Curtains labeled "heading tape" on each product page can be attached to the rails with your own adjuster hook. 

    Read more

  • I can not fit the screws for the MULIG clothes rack.

    When attaching the legs to the columns in step 3, if the legs are turned in the opposite direction, the screws will not fit. In addition, steel products have almost the same thickness of screws and screw holes, so there is a feeling that it is difficult for screws to enter. If the size of the screwdriver is not correct, there is a possibility that the screw thread will be licked, so please use a positive screwdriver that matches the size and install it so that you push the screw around with force from above.

    Read more

  • The drawers side panels are the same for both left and right.

    This product contains identical side panels. You can use them on the left or on the right side by turning them upside down.

    Read more

  • How I should look after my cutting boards?

    Before using the chopping board for the first time, it should be treated with oil approved for contact with food, for instance vegetable oil. Oil once, wipe off any surplus oil and then repeat the treatment 24 hours later.

    Read more

  • When assembling BILLY, the bobbin-like parts (cam lock) did not come off. Is there a way to remove it?

    If you notice that you made a mistake on the front and back of the riser plate at the foot near the end of the assembly, instead of pulling out all the nails driven into the back board and reassembling, you can unlock the cam lock and assemble.

    Read more