The front panels on my BEST drawers keep bumping into each other, or there’s a gap between them.
Please check the mounting position of the drawer front plate and the vertical orientation of the drawer front plate.
In this product, the position of the screw hole that holds the front plate changes with the bottom drawer and the second or higher drawer from the bottom.
It's also possible that you attached the panels upside down, so please check that this isn’t the case.
*Keep the front panel grooves at the bottom to attach the bottom panel.
See the videos about how to assemble BESTA （Japanese）
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
If you are combining drawers with shelves, the fittings for fixing shelves in place are different. Please use fittings attached without INREDA drawer fronts.
Read moreThis product contains identical side panels. You can use them on the left or on the right side by turning them upside down.
Read moreIf you notice that you made a mistake on the front and back of the riser plate at the foot near the end of the assembly, instead of pulling out all the nails driven into the back board and reassembling, you can unlock the cam lock and assemble.
Read moreIf you attach the backboard by mistake, you can remove it depending on the situation. However, basically, products that are assembled using nails cannot be disassembled and reassembled for use.
Read moreThis product contains identical side panels.
Read moreThere is a gap between the head/footboard and the mattress to make it easier to take out the mattress.
Read more