Good to know

Materials and care

Material

Table top

Particleboard, Layer-glued wood veneer, Honeycomb structure paper filling (100% recycled), Oak veneer, Oak veneer, Clear acrylic lacquer, Oak veneer, Clear acrylic lacquer, Oak veneer, Clear acrylic lacquer

Leg

Solid wood, Oak veneer, Clear acrylic lacquer

Chair

Leather:: Through dyed full grain leather from cattle

Smoulder resistant lining:: Polyester wadding

Frame:: Solid oak, Adhesive, Stain, Tinted clear acrylic lacquer

Backrest:: Layer-glued wood veneer, Oak veneer, Stain, Tinted clear acrylic lacquer

Seat:: Fibreboard

Bracket:: Layer-glued wood veneer, Stain, Tinted clear lacquer

Comfort material:: Polyurethane foam 35 kg/cu.m.

Backing:: 100% polypropylene

Stitching thread:: 100 % polyester

Care

Wipe clean with a cloth dampened in a mild cleaner.

Wipe dry with a clean cloth.

Protect from direct sunlight to prevent drying-out.

For increased stability, re-tighten the screws about two weeks after assembly and when necessary.

Safety and compliance

This table has been tested for general, non-domestic use and meets the requirements for safety, durability and stability set forth in the following standard: EN 15372 and ANSI/BIFMA X:5.5.This seating furniture is tested and complies with relevant strength and durability standards. The tests simulate typical usage of the product and are based on use by persons weighing up to 110 kg.This seating furniture has been tested for public use and meets the requirements for safety, durability and stability set forth in the following standards: EN 16139-Level 1 and ANSI/BIFMA x5.4.

Assembly and documents