Can I buy cover panels to ENHET?
ENHET is not designed to be a comprehensive system, and therefore there are no cover panels or filler pieces for ENHET, only a plinth to close the space to the floor.
In spaces towards the wall, up towards the ceiling, and in other places where filler pieces are usually used, we recommend leaving the space open.
For ends facing the room, we recommend not installing any cover panels. If a plinth is used in the kitchen, it is installed to cover the space towards the floor, the same applies if an open frame is used next to cabinets with a plinth.
It is not possible to install cover panels as support for the countertop at the end of a row for appliances (dishwashers, washing machines, or refrigerators/freezers). Therefore, a row of ENHET cabinets cannot end with these appliances.
Did you find this useful?
Thank you for your feedback!
What particular parts of our articles do you find unsatisfactory or unhelpful?
The text is confusing to understand
The text is not relevant to my question
The text is relevant but not helpful
The text is too long or too short
Thank you for your feedback!
Was the article not helpful? Try one of the related articles below.
Yes, sure, you can. Give your cabinet or wardrobe a complete look with VARIERA or KOMPLEMENT cover plugs.
Read moreOur ENHET system is designed to be easy to plan and combine! Therefore, we offer three widths: 40 cm, 60 cm, and 80 cm, two heights: 60 cm and 75 cm, and three depths: 60 cm, 40 cm, and 15 cm for our ENHET cabinets. You can then choose between closed cabinets (with drawers or doors) or open frames. However, we cannot yet offer all frames and cabinets in all combinations of dimensions or in all colors.
Read moreThe cover panels are wider than the frame to cover the space created between the wall and the frame cabinet when you mount the frame on the METOD wall rail. They also extend a bit further to align with the front that is mounted on the frame.
Read moreTo make it as easy as possible to attach cover panels to the kitchen island, we recommend using the METOD connector rail for cabinet and cover panel.
Read moreWe recommend applying masking tape on both sides of the cut, as the tape reduces the risk of splintering. Use the finest-toothed saw possible.
Read moreIf you have a row of base cabinets with an open end that ends with a dishwasher, you need to add a cover panel that goes from the floor up to the countertop. This is because the countertop should not rest directly on the dishwasher or on a refrigerator or freezer.
Read more