A clean and simple look that fits just about anywhere. You can combine it with other desks or drawer units in the MICKE series to extend your work space. The clever design at the back hides messy cables.
Material
- Table top/ Side panel/ Bottom panel:
- Particleboard, Particle- and fibreboard with honeycomb paper filling (100% recycled paper), Fibreboard, Acrylic paint, Plastic edging, Plastic edging
- Supporting leg:
- Particle- and fibreboard with honeycomb paper filling (100% recycled paper), Fibreboard, Acrylic paint, Plastic edging, Plastic edging
- Cable management/ Back rail/ Shelf/ Front:
- Particleboard, Paper foil, Plastic edging, Plastic edging
- Drawer side/ Drawer back:
- Paper foil
- Drawer bottom:
- Fibreboard, Acrylic paint
- Leg:
- Steel, Epoxy/polyester powder coating
Care
Wipe clean with a cloth dampened in a mild cleaner.
Wipe dry with a clean cloth.
For increased stability, re-tighten the screws about two weeks after assembly and when necessary.
Assembly instructions
MICKE Desk802.130.74
It’s easy to keep sockets and cables out of sight but close at hand with the cable outlet at the back.
You can mount the storage unit to the right or left, according to your space or preference.
Air ventilates effectively around your computer or other equipment because of an opening in the back panel.
Drawer stops prevent the drawers from being pulled out too far.
May be completed with MICKE add-on unit high.
Material
- Table top/ Side panel/ Bottom panel:
- Particleboard, Particle- and fibreboard with honeycomb paper filling (100% recycled paper), Fibreboard, Acrylic paint, Plastic edging, Plastic edging
- Supporting leg:
- Particle- and fibreboard with honeycomb paper filling (100% recycled paper), Fibreboard, Acrylic paint, Plastic edging, Plastic edging
- Cable management/ Back rail/ Shelf/ Front:
- Particleboard, Paper foil, Plastic edging, Plastic edging
- Drawer side/ Drawer back:
- Paper foil
- Drawer bottom:
- Fibreboard, Acrylic paint
- Leg:
- Steel, Epoxy/polyester powder coating
Care
Wipe clean with a cloth dampened in a mild cleaner.
Wipe dry with a clean cloth.
For increased stability, re-tighten the screws about two weeks after assembly and when necessary.
- When completed with an add-on unit, the whole combination must be placed against a wall to avoid the risk of tipping.Maximum evenly distributed weight is 50 kg. Do not place concentrated weight exceeding 15 kg on a small surface on the desk.This desk has been tested for domestic use and meets the requirements for durability and stability set forth in the following standards: EN 12521 and EN 1730.
Assembly instructions
MICKE Desk802.130.74
- 802.130.74
1 × MICKE
Desk- Width: 74 cm
- Height: 11 cm
- Length: 112 cm
- Weight: 28.00 kg
