Skip to main content
EN JPEnglish

The shelf support parts of the MICKE desk with storage are stiff. I can’t get them in.

The shelf supports will be stiff when you fit them, so please use a hammer as necessary. If you have to remove them, try using pliers.

What particular parts of our articles do you find unsatisfactory or unhelpful?

The text is confusing to understand

The text is not relevant to my question

The text is relevant but not helpful

The text is too long or too short

Thank you for your feedback!

Was the article not helpful? Try one of the related articles below.

  • What is the weight limit for IKEA products?

    Check the IKEA.com product pages, as several of our products contain information about load capacity.

    Read more

  • The casters of the swivel chair do not work, is this defective?

    While sitting in the chair, try moving it forward, backward, left and right.

    Read more

  • The desk board of MICKE is so hard that screws cannot be inserted.

    Slowly push it from above

    Read more

  • What sort of screws should I use to anchor furniture to walls?

    IKEA recommends you to use wall fixing screws that are suitable for your walls. As wall materials vary, screws for wall fixation are not included.*

    Read more

  • HYLLIS/I can't screw in the screws.

    Allow play without overtightening the screws and assemble them while adjusting. If the sides of the shelf are wide, use pliers or the like to bend them inward to facilitate screwing. If you assemble while tightening all the screws, the screw holes will not fit in the later process.

    Read more

  • Can I remove the nails on the backboard that I installed by mistake?

    If you attach the backboard by mistake, you can remove it depending on the situation. However, basically, products that are assembled using nails cannot be disassembled and reassembled for use.

    Read more