Cord stop retrofit kit for IKEA roman blinds Instructions for fitting cord stops
Safety is the highest priority at IKEA. Adding cord stops to your roman blind operating cords will reduce the possibility of injury, including strangulation, to children caused by entanglement in cord loops.
INSTALL CORD STOPS
- Lower the blind to its proper length and lock cords into position at head rail.
- Pinch together a portion of the pull cord to create a loop near the head rail, then slide the cord stop over the loop end.
- Slip the free end of the pull cord through the loop to loosely knot the cord stop onto the pull cord.
- Tighten the knot to secure the cord stop one to two inches below the head rail to limit movement of inner lift cords.
- Be Aware. If the ring/ bead slides and does not keep safety device in position, secure with two additional knots.
For each pull cord:
We apologize for any inconvenience this may cause. For further information please contact your local IKEA store.
[Picture] IRIS with cord stops fitted
